As of November 1, 2015 I will no longer be taking commissions for end user hilt parts. I will be leaving these pictures up as a reference for work I have done in the past.
Here you will find examples of what we can do in hilt parts. Understand that these are only 'examples' of what we can do, there are endless variations and designs that can be made. Our parts are milled and so are quite clean and true, without voids, twists and other problems that can sometimes happen using some other methods. We take great care to maintain symmetry and give the parts a high quality finish, our parts are high end custom pieces that are used by custom sword smiths around the world. These are milled from mild steel (we can mill them from Brass or Bronze - may add a week for completion and the cost is higher because of the higher cost of materials) and can be milled, finished and shipped usually in 10-12 weeks ( ---Check Policy Page for details--- ). The more complex examples shown here and custom designs will take longer and will come in at a higher price.
As a general reference a Pommel or Guard in the 'general' design area of what is shown in the first group run between $125 - $155 per piece, asymmetrical and more complex designs at the higher end (most of the disc pommels run toward the lower end and some of the more complex guards run to the higher). The grade of finish can also effect the price. If one goes to very complex, exotic designs the cost can only be worked out by examining the design in question. If you would like an exact quote just email us the details of what you are looking for and we will work it out for you.
In this second group we have some more complex designs. These run from $160 - $269 per piece and again if one goes to very complex, exotic designs the cost can only be worked out by examining the design in question. If you would like an exact quote just email us the details of what you are looking for and we will work it out for you.